10×10 Tension Fabric Booth with Curved Backwall, Center Arch Extension & Display Mount

This exhibit display booth is built around depth. Not just visual depth, but literal physical depth that brings structure into the booth space rather than keeping everything flat against the back wall. Start with the curved-corner backwall spanning the full width with side header panels at left and right. In front of that, a raised center panel sits approximately one foot forward and slightly taller than the backwall, creating a layered graphic effect that reads as dimensional from the aisle. From the top of that center panel, an arch extends all the way to the front of the booth space, curving down at the front edge so there’s no obstruction moving around inside. The monitor mount sits on the front face of the arch at eye level, visible from well outside the booth.

The shelf arrangement follows the geometry. Three MDF banner shelves run across the back, one per third of the width, sitting behind and beside the center panel for product display or literature. Two additional MDF surface shelves sit against each face of the arch base at the front of the booth, putting product and marketing material directly below the monitor mount where visitor attention is already going. Four LED overhead lights keep everything evenly lit.

No counter is included in the base configuration, which keeps the front of the booth open and walkable; any ExhibitBoss counter can be added as an upgrade. Every order includes 3 hours of graphic design and a free 3D render before anything ships.